Specialist engineering support for marine, BESS and vehicle electrification projects — from one-off prototypes through production ready system architecture, control, validation, compliance planning and commissioning.
Specialist consulting across battery systems, high-voltage DC electrification, and embedded control — from architecture through to commissioning and field support.
Embedded control design, model-based development in MATLAB / Simulink, and CAN-based network architecture. Plant modelling for real-time simulation and HIL testing.
Design and delivery of hardware-in-the-loop test rigs for full end-to-end control system validation — powertrain testing, flight control verification, and automated test workflows.
Production-quality low-voltage wiring harness design for marine, automotive and industrial applications. Connector selection, routing, gauge sizing and full documentation output — designed right the first time.
Hands-on installation and commissioning support for electrified systems across international sites — fault-finding, system bring-up, and on-site troubleshooting. Warranty engineering support including root cause analysis and field resolution.
Built on hands-on experience delivering production-ready, first-of-type battery electric hydrofoiling workboats — covering BMS architecture, high-voltage DC electrification, embedded control software, HIL validation, and international commissioning. The work is technical and practical, not just advice and documentation.
Real engineering outcomes — not advisory reports. Each project below was delivered hands-on, from architecture through to commissioning and field support.
103 kWh marinised Li-ion battery system for first-of-type electric hydrofoiling vessels — BMS logic, system integration, commissioning and sustained field support across international sites.
High-voltage DC power distribution, protection coordination and system-level integration for electric marine platforms — delivered in production across a first-of-type commercial propulsion programme.
End-to-end control-system validation using Speedgoat / MATLAB / Simulink — covering powertrain testing and flight-control software verification. Designed and delivered from blank sheet to verified test workflows.
Whether you're developing a new battery system, navigating a certification process, or need hands-on commissioning support — Bracka Engineering is ready to engage, remotely or on-site.
Available for contract and consulting engagements internationally.
Industries: marine, BESS, HME electrification, motorsport.